Dishwasher Water Supply Through Floor

Leave about six feet of cable sticking through the hole by the dishwasher.

Dishwasher water supply through floor.

Your unit may be taking in more water than it should and not draining properly. Adjust the leveling legs with a wrench until the dishwasher is perfectly level. Then install 12 awg cable from the dishwasher space to the service panel. When enough water has filled the dishwasher the rising float switch is supposed to tell the dishwasher to stop the water flow.

Connect the drain hose according to manufacturer s instructions. If you see water in the dishwasher when you are not using it check the water inlet valve for faults. This valve can malfunction and fill the dishwasher with water when not in use. Turn on the water supply inspect for leaks and tighten connections if necessary.

The moment you notice your dishwasher is or has leaked make sure to first turn off the dishwasher. To add a circuit cable drill a hole down through the floor into the basement or crawlspace. Connect the water supply line to the dishwasher. Then get on the floor to connect lines to the dishwasher.

It can help to have a helper under the sink carefully feed the water supply tube and drain hose through the hole in the cabinet s side wall as you pull the appliance out from under the countertop. Extend the stainless steel braided water supply hose from the sink cabinet out to the dishwasher. Replace the dishwasher s front panel. This will force water out of your dishwasher and on to your floor.

Use a drill driver to screw the dishwasher s mounting tabs to the underside of the countertop. Drill the hole for the dishwasher drain hose at this location. If this valve is faulty the dishwasher can fill with water and overflow onto the floor. You may be experiencing problems with the drain itself or the float valve isn t sealing properly.

Connect the water supply line to the 90 degree fitting using pliers to ensure a tight fit. The dishwasher is supplied with water from the water inlet valve. To avoid scratching the floor lift slightly as you pull the dishwasher out of the cabinet. Grab a towel or mop and soak up any visible water on your floor.

The float switch is stuck or broken. 3 drill another 1 inch hole 6 inches below the hole for the hose to feed the copper tubing water supply line at the back of the. The float switch is usually a plastic disc or cone that is attached to the floor of the dishwasher and is able to move up and down a few centimeters. This might mean pulling the unit out from under the counter so you can get any water that has pooled beneath the dishwasher itself.

Carefully slide the dishwasher into place.