Drive Nails Into Concrete Block

Be careful not to bend the nails as you drive them.

Drive nails into concrete block.

This will leave a small amount of the block holding the nail. The same way if you were to shoot glass with a bb gun or something similar the side you shoot has the small hole the other side has a larger portion of the glass blown out. Normally what happens when nailing into a block is the block will spall toward the inside of the block. The easiest approach is simply to nail the wood to the concrete.

These nails are driven through a board and into concrete underneath much like nailing a wood board to a wood floor. Hammer actuated tool with a barrel design that allows for easy horizontal and overhead fastening up to 2 1 2 in. Remove the nail and resume drilling. Reposition the board over the pilot holes aligning the board with the marks on the floor.

For small diy projects such as fastening two by fours and furring strips to concrete in basements or room additions. Continue striking the hammer until the nail is driven in to where you want it. The hammershot can easily fasten up to 2 1 2 in. This tool is great for small diy projects.

The hollow cores of the concrete block will just collapse if you try to drive a nail. The cut nail and the concrete nail. The cut nail has a square tapered shape with a square tip. Insert concrete or masonry nails into the holes and drive them flush to the surface of the wood using a framing hammer.

Use carefully aimed hammer strikes to drive the nail into the concrete wall so you don t miss and bend the nail or strike the wall and damage it. If you encounter an obstruction stop the drill and remove it from the hole then insert a masonry nail with the tip touching the block. If you re fastening something to the concrete wall drive the nail all the way in. Tap the masonry nail lightly with a hammer to break up the obstruction but do not drive the nail in completely.